Do you have a guide for connecting the CC 6UL with a 8-bit MCU interface display.

Embedded Devices Linux
, ,
1

I was hoping to use the ILI9342 display controller, the CC 6UL starter kit and Yocto linux.

Edit:

I read in the documentation somewhere that 8-bit MCU display was supported via the 40 pin RP header.
However 2 required signals are not provided on the RP header, am I misunderstanding something or is another display interface used ?

Display pin______6UL pin______6UL Name_____RP Header pin

RESET______________??______?
CS_________________59_________GPIO3_4__________11
D/C________________57_________ENET1_PWR________NC
WR_________________56_________UART4_TX__________8
RD_________________69_________UART4_RX_________10

D0_________________60_________PWM1/I2C3_SDA____27
D1_________________68_________PWM2/I2C3_SCL____28
D2_________________66_________GPIO3_7/PWM3_____33
D3_________________61_________PWM4_____________32
D4_________________58_________ENET1_INT#_______NC
D5_________________64_________GPIO3_10_________13
D6_________________62_________USER_LED_________22
D7_________________63_________GPIO3_12_________18

1 Like
2

HARDWARE REFERENCE MANUALS
ConnectCore 6UL Module
http://ftp1.digi.com/support/documentation/90001523.htm
Pages 33-51 are listing Castellaed pads. Search for anything that has LCD_

60 / A18 CPAD60 LCD_DATA0
68 / A10 CPAD68 LCD_DATA1
66 / A12 CPAD66 LCD_DATA2
61 / A17 CPAD61 LCD_DATA3
58 / A20 CPAD58 LCD_DATA4
64 / A14 CPAD64 LCD_DATA5
62 / A16 CPAD62 LCD_DATA6
63 / A15 CPAD63 LCD_DATA7

56 / C21 CPAD56 LCD_CLK
57 / B21 CPAD57 LCD_HSYNC
67 / A11 CPAD67 LCD_VSYNC
59 / A19 CPAD59 LCD_RESET (Pin 11 on the connector GPIO3_4)
69 / A9 CPAD69 LCD_ENABLE