The mesh consist in three points:
1 end device as analogue sensors signals Rx.
1 router device to operates a pump and connects the end device and the coordinator due to the distance.
1 coordinator to Rx the signal and Tx the on - off signal to operates the pump.
The sensors signals are analogue and the on-off signal is a digital one.
How to configure these devices?
Regards
Nicolas
What do you mean by “configure”?
Are you asking how to set up the ZigBee network?
Are you asking how to set up the sensors?
Are you asking how to set up the Rx/Tx triggers on the coordinator?
Hi DystopianFerret,
Thank you very much! I’ve been working on several issue, however I would like to retake this subject. My doubt is how to set up the Rx/Tx triggers on the coordinator?
Kinds Regards