Hello!
I am using two XB24-Z7WIT-004 modules. one as API
coordinator and other as AT router. I want to check the status of switch attached to coordinator and show corresponding status on led attached to corresponding pin of router.
I want to know configuration parameters needs to be set and their values?
Thank you
Try using the IC command to tell the system to monitor the line in question.
I ALSO HAVE SAME PROBLEM BUT WHAT I AM GETTING IS
SET ONE AS CORDINATOR API MODE
OTHER AS ROUTER AT MODE
SET THEIR ADRESSES CROS IN DH AND DL.
MAKE FRAME 17(REMOTE AT MODE) SET ADDRESS OF REMOTE RADIO AND AT COMMAND LIKE D0,D1,D2 FOR DIFFERENT PIN.
PARAMETER VALUE 01,02,03,04,05 AS YOUR REQUIERMENT.
YOU WILL RECIEVE PACKET BUT CAN`T CHANGE STATE.