iomux port setup discrepancy for connectcore 6ul sbc pro

Embedded Devices
, ,
1

Hi,
I’ve noticed a discrepancy in iomux when starting from template for CC6ul SBC PRO wifi/bluetooth.
The UART labeled as “Serial port” is mapped as “UART2”, while the schematic for the same board shows “UART3” is connected. And vica versa for the UART labeled “Xbee”.

So it seems like the UART port references (UART2, UART3) are wrong in IOmux tool.

Andreas

2

The team was already aware of this. This has been already fixed and will ready for the next release of the tool.