PC based Python control of a SmartPlug...

Hi All -

After much tweeking of Digi’s example SmartPlug Python code, I have basic PC control of a SmartPlug.

The setup is an XBee Adapter with a S2 XBee and a FTDI cable from Adafruit.

The modified Python files are attached below.

Make sure NO setting = 0x01 and DD = 0x0003000F on the SmartPlug. Also, NO = 0x01 and AO= 0x01 on the coordinator.

I can be reached at 772-257-one thousand for limited support.

Hope this helps,

Brad Norman
brad )at( green home gear ).( com