PORTSERVER TS 2 CONNECT WITH TLK

WHAT I HAVE TO DO FOR CONFIGURE TS2 WITH ATTACHED A TLK (TERMINAL BADGE ) ??.
I HAVE THE CABLE AS THE SPECIFIC IN MANUAL RJ45-DB25. BUT
I HAVE A BIG PROBLEM, I CAN NOT CONNECT PORTSERVER
TS2 WITH TLK (TERMINAL BADGE).
I HAVE A SOFTWARE WHERE IS CONFIGURED A LAN OF TLK WITH IP ADDRESS AND TCP PORT EXAMPLE: 10.10.0.2 PORT TCP 2050.
WHEN I DO SETUP OF TS2 I INSERT IP OF TS2 10.10.0.2 BUT I DON’T KNOW WHERE I CAN INSERT THE TCP PORT AND WOULD BE KNOW IF I MUST SETUP THE OTHER FIELD.

THANK YOU VERY MUTCH.

I CAN CHANGE TCP PORT FROM SOFTWARE IF IS NECESSARY. IF A POSSIBLE MAY I HAVE A CONFIGURATION FOR SETUP OF TS2 FOR MY PROBLEM???

AGAIN THANKS

It sounds like you’re trying to console this TLK.

If so, what you would want to do is telnet into the Portserver TS2 and send the following commands after logging in as root (default pw: dbps):

(The following example will be used to configure port 2 of the Portserver TS2.)

#> set ports range=2 dev=prn

#> set line range=2 ?
(use the set line command to set correct baud rate, parity, etc. at this point)

#> set flow range=2 ?
(use the set flow command to set flow control to match however the TLK is set)

#> kill 2

To access the TLK connected to port 2 of the Portserver TS2 from your application, you will want to use the IP address of the Portserver TS2, with TCP socket 2002. The TCP socket number is the sum of TCP Base Socket (2000 by default, see “set config ?” for details on how to change it) plus , i.e. 2002 in the preceding example. If your TLK needs a binary socket connection rather than ASCII, use socket 2102 instead (2100 being default binary socket base).