Program Stops when forceSoftReset() is called when using Dyn C

Works fine when running stand alone. When running under Dynamic C the program stops responding, although the status bar still says “Running Polled”

When I hit STOP then RUN in DC it starts running from the beginning as intended

Stand alone it resets and runs from the beginning when forceSoftReset() is executed.

Any ideas?


Can you tell me version of dynamic C and what type of board are you using?


Dynamic C version 9.62

Board is BL2110 with Keypad/Display 101-0466

I think if you run the application through the Dynamic C , after uploading the bin file on to the flash you need to remove the programming cable from the board…