RCM2100 idc socket adapter?


I’m trying to figure out the right part to connect the RCM2100 to a few prototype boards using standard 2.54 mm spacing. The header socket for the RCM2100 is 2.00 mm spacing, so I figure I need some sort of converter for the pins to the dev board, does such a thing exist? I’m pretty new to this so I may be confused about the way that people might usually do this.

I was trying to find products like this:


…that go from one pitch (2.00 mm) to the other (2.54 mm) but I can’t seem to find anything, does anyone have any advice?