I want to know the exact route information of a router module right now…
I think that I can draw the network path if I use ZDO command “Management LQI (Neighbor Table) Request” and
“Management Rtg (Routing Table) Request”.
I think the “Management LQI (Neighbor Table) Response” is proper.
But “Management Rtg (Routing Table) Response” is not proper.
It doesn’t show all route information of the router module.
I set AO = 1 in the AT command.
There are one Coordinator(C) and two routers(R1, R2).
And they are within the proper RSSI(-75 dbm).
I think that they are connected with Mesh network.
So, I think that R1’s route table shows R1-C, R1-R2-C(hopping)…
But sometimes R1’s route table is nothing…
Sometimes R1’s route table shows partial information (R1-R2-C or R1-C)…
I tried many times…
But It didn’t update the route table.
- I referred to X-CTU’s network working mode…
When I selected the “Scan” button, the Consoles working modes shows the ZDO messages.
Generally, I think that it shows X-CTU’s route table well.
But sometimes it shows the same situation…
It shows strange network address information in the route table entry…
But the Network working mode shows the network graph well…
How did you draw it?
I’m not sure your policy or scenario…