simple test…
I have the two units in transparency mode and have each others mac address asigned as per an online tutorial.
all worked fine until I reconfigured for coordinator/router combination…
going back to working configuration no longer works. updated firmware, reset modules and started fresh…still no luck.
any other methods of confirming comms…???
Spectrum analysis from either Xbee yields results…so radios working…
Feeling quite stuck!
can i know the configuration details about coordinator and router device
Configuration is default except for…
- NI = Name of the device
- ID = 2016
- DH = 0014A200
- DL = SL value of the other XBee module
There are only 2 modules and the configuration is the same for both (except DL/SL value of course)
This WAS working till I changed the operation to COORDINATOR on one of the units and changed to API mode…when this didnt work, I tried to revert to original configuration which no longer works…FIrmware downloads and reconfiguration to known working config (as above) no longer works.