setDIOChangeDetection

Hi all,
I don’t know if this is the rigth category to speak about zigbee.

I am using S2 pro and I am not able to use setDIOChangeDetection capability.

Does anyone have the same problem? or similar?
I could post the code and configuration if needed.

Regards,
Matteo.

The IC command is a Bit mask where each bit is an enabled line. Have you enabled this function? Are you trying to perform a Digital IO line pass function?

Hi,
thanks for the answer, but I have solved my trouble. It was my fault, I had set AO to 1 (explicit) on coordinator, so it translated the sample message in explicit message.

Bye,
Matteo.