XBEE MIDI BOUDRATE

XBee & XBee Gateway XBee Programamble (S2C & 900 HP)
1

Hello everybody!
I’m working on a wireless project using Xbee radios.
The project consist in 2 xbee PRO, 1Xbee shield , 1lilypadxbee, 1lilypad Arduino, 10 square led.
The goal is to switch ON/OFF the 10 leds that are solder on a dress.

To send the On OFF signal I use a Midi man plugged in a Mac computer, that sends midi notes directly to the xbee shield (through a midi jack connected to the shield)
The 1st xbee plugged to the xbee shield have to send midi signal to the 2nd xbee plugged to the lilypadxbee.
Then the lilypadxbee resend the signal to the lilypad arduino (links to the Lilypadxbee) where the 10 leds are connected to the respective pins.

I tried to make it work once,2 months ago, and the leds responded well.

Now I’ll tried to make it work, but something is missing.

I reconfigure the 2 Xbee with a midi boudrate 7A12.
Even if the midi man sends signals the xbee is not able to read it.

Maybe I think that the usb drivers are not jet to the computer (even if I istalled it a lot of times)

Where is the mistake?

Plus did someone knows a xbee soft that is capable to comunicate between to xbee even if I’m not using a custom boud rate? (that we usually fond in XCtu or cool term).

Thank You everybody

I’m quite desperate

2

hmm… I think you are in the wrong category thread… Then again, Digi is quite misleading when they said “Programmable” to the layman. lol

I suggest you try asking here: http://forums.digi.com/support/forum/listthreads?forum=5. There are more listeners who are willing to help there…

This thread is for the HCS08 uP that’s coupled with the original XBee Series 2 Radio.

Anyway, show us the printscreen shot of the X-CTU front panel after you connect your shield to the PC… We can then verify whether the driver had been correctly installed or not.