Hi
I am trying to communicate Picdem z modules with Xbee series 2 coordinator.
Eveb after configuring Pic to work on the same channel, pan id as the xbee , Xbee doesnt communicate with my PICmodules.
What are the configuration need to be done in xbee?
There is a extra 64 bit address header in the Xbee packet?What is the way of getting rid of it?
You say your modules are series 2, but this is a series 1 forum. If you check what firmware your modules have (eg ZB or ZNet) and ask in the forum appropriate for it you’re likely to get a better response.
Hope it helps.