I see the device into “AnywhereUSB Remote Hub Utility” but I never have access to the Configure button (in Connect and Disconnect state).
So I tried with Telnet to change the IP settings.
With the command “set network”, I see that I changed the “Stored configuration” but never the “Currently in use by the network stack”.
Is there any WebUI with this device? I can’t open it.
The AnywhereUSB/5 Gen 1 does not have a web interface. You should be able to click the Configure button to set the ip address settings. The AnywhereUSB/5 Gen 2 has a web interface. The AnywhereUSB/5 Gen 2 with the 1.38 firmware and later, the Configure and Reboot button have been disabled. You must use the web interface or device discovery to configure the ip address settings.
http://www.digi.com/support/kbase/kbaseresultdetl?id=3290
Here is a link to the AnywhereUSB installation guide that should help you further if needed:
Thanks for your answer.
I finally found that a proxy filtered the WebUI.
Now with the WebUI access, the IP configuration is well applied and so the issue is resolved.