ATWR command doesn`t give any feedback

XBee & XBee Gateway XBee - Zigbee
1

Hello,

Because I am just started with Xbee`s it is possible that this problem what I have is possibly a problem with a very simple solution, but I am searching for hours on the internet without a good result.

So, I really hope that there is someone who could help me here :slight_smile:

I have one xbee (S2) which is set to znet 2.5 coordinator AT version 1047 and another one (2 series) set to Znet 2.5 router/end device AT version 1247.

They are able to see each other, but when I will save the firmware with ATWR X-CTU did`t give any feedback…nothing :S

If someone gives an answer, please keep it very very simple :wink:

Thanks! :slight_smile:

2

I don’t use X-CTU very often but maybe this is its normal behaviour?

Try changing a parameter value such as the state of an I/O line. Then power down the XBee and reconnect, and see whether X-CTU reports the value you had set. If so, then ATWR has worked even though you got no feedback.