ConnectionPort (coord) X4 and CC2650STK SensorTag (end-devices)

Hi,

The ConnectionPortX4 gateway device has just arrived. I need to make it communicate with the Texas Instruments CC2650STK cards.
The zigbee firmware with Zigbee HA profile has already been loaded on these cards. I would like to understand how to set this profile on your CPX4 product too.
I have to use XCTU (in this case, how do I connect to the gateway: via USB cable), or from the same CPX4 web page?

On the CC2650STK boards I have already changed the Extended-PANID and the channel.

Network topology is simple:

  • CPX4: coordinator of Zigbee network
  • CC2650STK devices: end-devices of Zigbee network

thanks…