Good day
I have recently purchased 2 RCM 6700 and 1 RCM6750, and previously a RCM6700 Standard Development Kit with a RCM6700 in.
When I try to load software (with Dynamic C 10.72) in any of the 3 new ones, I receive the following answer:
line 19 : WARNING SYSCONFIG.LIB : DC_CLK_DBL should always be defined, but was not defined:
line 20 : WARNING SYSCONFIG.LIB : Defined DC_CLK_DBL to 0 (disabled clock doubler recommendation).
line 27 : ERROR BOARDTYPES.LIB : No ID Block found on the target board.
line 28 : ERROR BOARDTYPES.LIB : Please contact Rabbit Technical Support at http://www.digi.com/support for assistance.
I have defined DC_CLK_DBL both to 0 and 1 with the same result.
Thanks in advance