Error writing for AT parameters while configuring Xbee S6B module

XBee & XBee Gateway XBee - WiFi
,
1

I’m trying to configure Xbee S6B, but I’m getting
Error writing the following AT parameters
-GW: status error
-MK: status error
-MY: status error

How to solve this problem

2

What version of Firmware are you working with? How are you writing these parameters?

3

I’m trying to configure Xbee S6B (Firmware 2021) with XTCU, but I’m getting yhe next message:
Error writing the following AT parameters

-GW: status error
-MK: status error
-MY: status error

Parameter MA is DHCP.

If I change to static and write I can write GW, MK and MY too. But if I change MA to DHCO again then GW, MK and MY are set to 0.0.0.0