have xbee pro s3b with foca v2.2 breakout to usb
using x-ctu but doesnt test
installed some new drivers but didnt do anything
doesnt communicate
cant get off ground
not that knowledgeable
guy at support @ digi said something about pin 2 & 3
i guess thats on the xbee
not sure what to do
I would suggest that you getting an XBIB-U-DEV development board. It will save you a lot of headaches.
Have you talked with Foca’s support about it? You may need to cut a trace as the XBee S3B XSC uses different pins for some of the lines. Doing a quick comparison between the Boca schematic (http://store.iteadstudio.com/images/produce/Shield/Focav2.1/sch-foca-v2.1.pdf) and the XBee’s product manual, (http://www.digi.com/support/productdetail?pid=5298&type=documentation) should allow you to verify that.