is dnp 3.0 supported by digi transport wr44 through serial?

Digi TransPort WR (Series)
,
1

I am having trouble receiving data from a remote RTU via DNP . where under management under connections tab, it will show my servers IP connected to it but will not receive any data from the RTU, but will receive data via ASKII.
Does the WR44 support DNP through the Serial port? if so what will be best way to setup?

Thanks,

2

Do you poll the RTU from the outside? If so, configure your WR44 serial port to listen on port 20000. If the RTU initiates the connection (very odd that it would), then set the outbound port to 20000. You should be able to use the Serial Port Wizard to set this up.