Is there any documentation on how to control XBee sensors


I have 2 XBee (Zigbee) sensors that I want to connect to my my Zigbee coordinator.
I have started with one and I am stuck on the way to get access to the input data (temperature/light).
I can configure (PAN ID and coordinator address) the module through XCTU, but no way to have access to data. I believe that it was suppose to send data autonomously. The IR command is not available. I have tried the IS command, but got an error.

I haven’t found any available documentation on detailed operation.

The front LED is blinking fast, but I am not able to check if this is normal or a sign of failure.


You need to use API mode and issue an IS command. You then need to calculate the data.