Problem with a xon/xoff flow control in a digi acceleratot 8 port

[ralph]

Hi I have a digi board with Red Hat Linux 7.2.
The problem is that when I send a job and if the printer is not ready or is off the job is send and when the printer is ready the job is over.

Also we have seen that when the job have more than nine page at the page 10 the printed information have not sense , all is garbage , it seam to be that the xon/xoff is not working properly

[michaelt]

Possibly a flow control issue. We have several documents describing printer setup in a Linux environment in our Knowledge Base.

If you don’t find what you’re looking for there, more indepth troubleshooting might be needed so it would be a good time to call Technical Support.