Hi,
I have the lastest Digi Connect ME on my eval board.
I have a raw TCP connection on port 502
I connected to this port on the Connect ME successfully
The problem is,
I lower the DSR to activate the RCI port.
I then send the following via the serial port
I get the full response back from the Connect ME - no problem
However, now my TCP raw port does not work anymore - will not connect no matter what state DSR is in or whether I completely reboot the system - power removed etc.
The only way to get arround this TCP raw port “lockout” is to launch the browser and reset the Connect ME to factory defaults.
Why does a simple RCI query lock me out of my TCP raw port and why does it only start working again after reseting to factory defaults?
Frank