Remote ATER command not returning correct data

XBee & XBee Gateway XBee Programamble (S2C & 900 HP)
,
1

Using Firmware 8070
Model#: XBEE PROS3B

When I send a remote ATER command I get a number back. When I send ATER0, in order to set it back to zero. I get a 162 decimal back. No matter what the value was when I sent it, when I set it to zero, and ask it for the ATER again. It always gives me back 162 instead of zero.

Any thoughts why this is the case?

2

this is not the case with my modules. May you are doing it in different way or these units are faulty.

Can you add a screenshot here to make sure that we are on same page.

3

The ATER or Error Count command is NOT a settable parameter. It is a Read Only value. You must reset the module in order to reset this or any other read only value.