Replace a Coordinator under 802.15.4 network

XBee & XBee Gateway XBee - Point-to-Point/Multi-Point
, ,
#1

Hi
I m using S2C to setup a network using the 802.15.4 under XCTU.
Could anyone tell me if I lost the coordinator and looking forward to replace a new one?
Are there any guideline showing how to setup this new Coordinator?

Or I must to use the Zigbee network set up in the XCTU? If so, Could anyone provide a guilde here?

Best Regards
Wirop

#2

On the 802.15.4, it is nothing more than setting the same PAN ID, channel, DL/DH, MY, CE, and A2 settings as your old coordinator. Then swap them.