SX900 cannot set channel mask

I would like to change the channel mask for SX900 which model number XBP9X-DMUS-001. I try to change the parameters CM but I cannot successfully change it. Even I change Data rate (BR) to 0 or 1.

Earlier, I have been use SX900 in the Australia version (XBP9X-DMUS-021). But it is no longer have that version in stock like now. So I brought US version and expected to changed CM to be use with Australia version

Thank you in advance

It is not possible to simply change the channel mask to match the channels used in Australia. While both are 900 MHz, they have different band widths and supported channels.

Is there anyway to upgrade firmware to Australia?

I already have it for 15 pcs. If you have anyway to have please let me know.

No, it is not possible. The frequencies are set at the factory. This is specially done to ensure that a U.S. version not be used in Australia as part of that certification also has to do with the Label.

Do you have any suggestions?

Because we already have it in hand. Can we able to do replacement or any others?

The only option is to talk to your place of purchase about exchanging the parts for the correct ones. Please understand that this is not just a frequency issue but a Certification issue. If I recall, Australia uses the 902. - 928 MHz just like the US. But if I recall it has a notch around 915 - 917 MHz which you can’t operate in. The U.S. version uses the entire 902 - 928 MHz band where by the Australian version does not.