Hello
I have Connect Wi-ME module but it has only 14 pin connector instead of the 20 pins which is stated in datasheet. Is there something wrong with module or am I looking at the wrong datasheet?
–
Tim
Tim,
Pins 1 and 2 are the Power OVer Ethernet pass-thru pins, seeing as it is impossible to provide power of wireless the pins have been removed. Pins 3-6 had always been removed to allow for “creepage and clearance”.
I will have to double-check the user’s guide to ensure that this is stated.
Cameron
> Pins 1 and 2 are the Power OVer Ethernet pass-thru
> pins, seeing as it is impossible to provide power of
> wireless the pins have been removed. Pins 3-6 had
> always been removed to allow for “creepage and
> clearance”.
Ok, that solves my problem. I was just confused by pins 3-6 showing in the picture.
–
Tim
Tim,
Exactly what document(s) and page number(s) are you seeing this information? I would like to get the information straightened out if necessary.
Cameron
> Tim,
>
> Exactly what document(s) and page number(s) are you
> seeing this information? I would like to get the
> information straightened out if necessary.
>
> Cameron
Digi Connect ME & Wi-ME
Hardware reference
At page 13 there is bottom view picture “Power and device interface connector”.
–
Tim
Tim,
Take a look at the very last page of this document. Check the part number and, more importantly, the document revision letter. I think that you are looking at a version of E or earlier.
This document is currently are revision F (http://ftp1.digi.com/support/documentation/90000631_F.pdf). In this version of the document it does indicate that pins 1-6 have been removed from teh Wi-ME.
Cameron
> This document is currently are revision F
> (http://ftp1.digi.com/support/documentation/90000631_F
> .pdf). In this version of the document it does
> indicate that pins 1-6 have been removed from teh
> Wi-ME.
My document was rev. B, so that was the reason.
Tim