xbee cellular on XCTU command mode

XBee & XBee Gateway XBee - Cellular
,
1

Hi,

I am using xBee cellular kit with XCTU to communicate with the modem.
I can read/write/edit the values in the Configuration mode.
But I cannot use it in the command mode in the console.

I am trying to create packet and then press ‘Send selected packet’. I never get a reply back from the modem. It only responds with ‘OK’ for the ‘+++’ packet. I have tried ATVL, ATVR, ATIM commands. But the modem never replies anything back.

Do I need to specify , in the packet? Am I missing some setting for the command mode?

Thanks & Regards,
Anuja Upale

2

Yes once you are in command mode, you need to issue the to issue an AT command. For example,

+++
ok
ATVR
Response