XBee-PRO XSC S3, 900 MHz API drivers


I am looking for API driver code for XBee-PRO XSC S3B, 900 MHz.

The links provided Your text to link here… and . Do not provide API driver code for the device.

I am looking for generic API driver code that is one that is not specific platform.

Actually any API driver code would work i would just modify it to work with my micro-controller UART.

The S3B XSC firmware and related hardware does not support an API interface.

I believe you are wrong. The manual ( http://ftp1.digi.com/support/documentation/90002173_M.pdf ) says it has API. The manual is for both the 900-HP and XSC. Also the manual is provided from here ( http://www.digi.com/support/productdetail?pid=5298&type=drivers ) which specifically dictates that it’s the correct manual for the product.

Alsothe libxbee library dictates that is supports s3b firmware in API mode.

So I believe you may be incorrect could an employee please confirm this.

The XSC S3B and XSC firmware does not support API mode. The section of the manual you are referring to that supports API mode is the 900 HP hardware and related code.

I notice that the manual only speaks about 900HP but I ignored that because the entire manual only speaks about the 900HP. If what you’re saying is correct where can I find the manual that speaks about the XSC running on s3b firmware

No the entire manual is not just for the 900 HP. Appendix A starting on page 93 is where the XSC portion of the manual is.