When use with DigiMesh 2.4 SMT pro version (B002).
Use the firmware version 4061.
I tried it but xctu gives me error 4061 not found in xctu.
Same as firmware version 4060.
It doesn’t support this hardware version?
Is this zigbee firmware version support all hardware version?
No it is supported. What I would suggest is to use the Help > update firmware library in XCTU.
Can you send me the ZIGBEE PRO firmware that this hardware supports?
This hardware version is XBP24CZ7UIS-005 Rev A.
From this document.
From the above message Am I correct that other XBEE Pro firmware are not compatible with this hardware version.
If so, what is the standard firmware version you recommend?
mvut Where are you?
mvut, please answer my question.
Hello,
The XBP24CZ7UIS-005
is a different version of hardware but is still compatible with the other S2C modules.
You should run the A063 firmware on the XBP24CZ7UIS-005 module and the 4060 for the XBP24C. Then set all of the modules to factory default, and then assign one as Coordinator (CE=1). The other 2 radios should then associate to the coordinator.
Hello Jay, Thank for reply.
It should be so, but it doesn’t.
As described at the first question.
These XBEE module (ZIGBEE PRO function set A063) is factory reset then set to same PAN ID.
AUTO CHANNEL (SC=0x7FFF).
But one module can’t join in the network, what do you think could be the cause.