hello forum … i’ve big problem with connect-me ethernet version … On my HW i give to module 3.3Volt but the chip don’t run … Leds are off and the sw DIGI DEVICE SETUP WIZ not recognize the module on lan the power supply is right on pin 15, the pin 20(\INIT) and 14(RESET) is pulled hight with 10k resistor , with oscilloscope on pin 14 there is 0.1 volt !!! What is the right schematic for this module ? and there is a particular sequence to give at power up … the module is preprogrammed ? what is the correct sequence of development HW/SW for this module ?? Thank’s in advance for every replay !!! Bye from Italy