Digi WIME and reset hardware

Embedded Devices Plug N' Play
1

Sorry for my bad english
Module Digi Connect WIME
Mac Address: 00409d2c6c91
Boot Version: 1.1.3 (release_82000942_E1)
POST Version: 1.1.3 (release_82000941_G)
I’ve buy this product and I’ve Integrated it on a custom board. I’ve tested and functionally correct. If I want to return at default configuration, I must do a short-cicuit with pins 14 and 20. There is another way to reset the device? If i lose SSID or IP there is a software utility to recover this parameter ?
Best Regards
Alberto

2

Shorting pin 20 to ground on boot up is the easiest way to factory default the module.

You can also factory default the module by going into the Web UI -> Factory Default.

Finally, if you’ve enabled RCI or the CLI on the serial port, you can go into it and change the SSID, etc.