In DigiMesh(firmware 8003), it was possible to send and receive it.
But, it is not possible to receive it with firmware 804B.
Equipment A Equipment B
(send) (receive NG)
±-----+ ±-----+
| XBee | ----------> | XBee |
±-----+ | ±-----+
|
|
±-----+
| XBee |
±-----+
X-CTU(monitor OK)
DigiMesh is a setting of default.
When the application starts, CH, NN, and ID are set by the AT command. (don’t write)
It was OK when reading it after it set it.
When CH, NN, and ID were set with X-CTU, XBee of equipment B was able to be received.
Why?