Further problems with Industrial Automation to communicate XBee Analog Adapter and ConnectPort X2D

XBee & XBee Gateway NDS-based Gateways
, , , ,
1

I am using a software that is able to talk to Modbus devices over TCP, which is addressed through the IP of the ConnectPort X2D. I have configured Industrial Automation of the CPX2D to have an Analog XBee Adapter in an specific address (with its RF MAC address), but I am still having connection problems when trying to access the analog registers in the XBee adapter. How can I forward RTU serial messages from mesh network to the CPX2 and out of it with MODBUS TCP?

Many thanks
Regards

2

If you are are using the Industrial Automation function in the CPX it should do that for you. You may just need to adjust your timeout values in your Server.