Hello …
I am a researcher and student.
I am developing some other things (Xbee pro-s2).
I’m having problems when in AT, I try to send msg from a terminal
teceber and in the other. With two modules connected
Using X-CTU software, and 2 modules (AT coordinator / End DEVICE AT)
and a USB (MaxStream - Model PKGU)
Mg I get the following: “Unable to monitor with event” "
So I can not success in communication.
Can someone help me?
The modules work seamlessly with the way API.
What is the best firmware model to do this?
XBP24-ZB or BXP24-B / Znet2.5 ???
Sorry the english.
Thanks
Hi menechine,
ZB firmware is better than Znet2.5, which was discontinued.
In order to get them communicating you’ll need to make sure:
-their PAN IDs (ID) are the same
-one module will need to be the coordinator AT. Set it’s DH = 0 and DL = 0000FFFF (broadcast)
-one module set as the router AT. Set it’s DH = 0 and DL = 0 (sends data to the coordinator)
You can then do a very simple test. Open XCTU for each module. Then go to the ‘terminal’ tab for each. start typing on your keyboard. You should see the characters appear on the other screen. that will show you that data is going back and forth normally.
Thanks For the answer,
I can do is communication (BROADCAST) perfectly.
My problem is the message that appears on the tab terminal X-CTU
The message is as follows:
“Unable to monitor with event” "
After the message, I lose communications with the modules, and can only again, when I disconnect them and connect again …
Help me in any solution please … Depending on this proojeto!
Thanks!
email me a picture of this please:
kjensen8@hotmail.com
make sure to attach your configuration files for both the coordinator and router. you can generate those from XCTU -> modem configuration -> save.
I’m not familiar with that message.
SOLVED!
I changed the USB cable from the board ZIGBEE, and the message stopped happening.
Thanks For Support.