I’m testing out the I/O line sampling feature and running into an issue where I only get one packet from the remote radio. If I reboot the remote it again sends one packet then nothing more.
My remote radio configuration is:
XBee Address
ATMY 5678
Destination Low
ATDL 1234
Group Address
ATID 1111
API Enable
ATAP 2
Baud Rate
ATBD 3
Set pin 20 to ADC input
ATD0 2
Collect data every 100ms
ATIR 64
Send data every sample
ATIT 1
Save
ATWR
My base radio configuration is:
XBee Address
ATMY 1234
Destination Low
ATDL 5678
Group Address
ATID 1111
API Enable
ATAP 2
Baud Rate
ATBD 3
Pass I/O data to UART
ATIU 1
Save
ATWR
When I start up the remote radio, it sends the following packet:
7e 00 0a 83 56 78 24 00 01 02 00 03 ff 85
7e Start Byte
00 Length MSB
0a Length LSB
83 API Identifier (Frame Data Start)
56 Source Address MSB
78 Source Address LSB
24 RSSI
00 Options
01 Number of Samples
02 Channel Indicator 1
01 Channel Indicator 2
03 ADC MSB
ff ADC LSB
85 Checksum
This packet looks correct (Nothing is attached to the ADC pin), but I never get any more packets from the remote. Thanks