I used the Digi ESP for Net+OS Version 2.0.0 to implement a custom application based on the Net+OS 7.3 for the Digi Connect ME module. I haven’t used for a while. Recently I am facing an issue, which the ESP IDE cannot connect with the Digi Connect ME module with JTAG interface on a development board. The SEGGER J-LINK GDB Server log window always show “WARNING: RESET (pin 15) high, but should be low. Please check target hardware”, “ERROR: JTAG Timeout during adaptive clocking: RTCK did not respond. Could not find supported CPU core on JTAG chain”. I don’t know where the issue come from. ESP IDE, JTAG LINK, development board, or module itself? I used the set to develop firmware before. Please let me know if you have any recommendation. Thanks!
The following is the screen capture:
J-Link connected
Firmware: J-Link ARM V8 compiled Nov 28 2014 13:44:46
Hardware: V8.00
S/N: 38001159
OEM: DIGI-LINK
Feature(s): GDB
Resetting target using BP@0 and trying again to connect…
WARNING: No matching core found. Selecting default core (ARM7).
WARNING: RESET (pin 15) high, but should be low. Please check target hardware.
WARNING: RESET (pin 15) high, but should be low. Please check target hardware.
WARNING: Received 0 as core Id.
WARNING: RESET (pin 15) high, but should be low. Please check target hardware.
WARNING: RESET (pin 15) high, but should be low. Please check target hardware.
WARNING: Received 0 as core Id.
ERROR: JTAG Timeout during adaptive clocking: RTCK did not respond.
Could not find supported CPU core on JTAG chain
ERROR: Could not connect to target.
J-Link connected
Firmware: J-Link ARM V8 compiled Nov 28 2014 13:44:46
Hardware: V8.00
S/N: 38001159
OEM: DIGI-LINK
Feature(s): GDB