HI ALL,
I AM USING THE ZIGBEE SERIES 2 MODULES WITH THE PART NUMBERS XBP24-Z7WIT-004. I CONFIGYRED IT AS THE END DEVICE AT MODE. NOW I WANT THE MODULE TO BE WORK IN THE 0-SLEEP MODE ALWAYS
THANKS IN ADVANCE
REGARDS,
JAGADEESH CHOWDARY
The definition of an end device is that it sleeps. If you want it to be mains powered and always on, then you need to install the router firmware on it instead.
hi muvt
thanks for u r reply.
i want to set an end device in which router does not need.
can any one help in this matter?
regards
jaggu
Jaqquchwdary,
Do you mean that you wanted to place a node in which it is not a router?
Are you aware that the only difference between a router and a end node is that the end node sleeps and does not have the ability to rout data?
ya u r right mvut
i need to have a node such that it wont act as a router
is it possible to convert those modules firmware to the nodes firm ware?
thanks in advance
regards
jaggu
I believe if you set the sleep mode to pin sleep and leave the radio awake, it may work. You may want to test that. Otherwise you will need to set it as a router.
hi mvut
i had tested the configuration with the pin sleep mode also. it is not working i configured it as the sleep mode my modules are going into sleep mode continuously.
now another problem arises. how can i change the pin wake up sleep mode to the router mode? because the module goes immediately into sleep mode and it is not responding to the x-ctu also.
can any one help to solve this problem?
regards
jaggu