I purchased the XBee-PRO 900HP Digimesh kit. It comes with shields and XBee Pro S3B. I am trying to interface these devices with STM32F303K8 for a telemetry system. I downloaded XCTU and it cannot discover the devices. I tried adding them manually as well. I have tried using the recovery tool and installing the legacy firmware, but no luck. Please help!
Check and see if the Loop back jumper is connected or not. For XCTU to talk to the radio, this jumper needs to be removed from the local radio (PC connected). Make sure you are also using 9600 baud, 8 data bits, no parity and 1 stop bit.
The loopback jumper is not connected, and I have been trying those settings. The reset dialog appears and when I press the button on the shield nothing occurs.
I would suggest you submit a case at my.digi.com. When doing so, make sure that you include as much data as possible including images, part number and any Error messages.