Recently I bought 3 Programmable Xbee from mouser but there is problem with these modules. Sometimes it connects to PC, sometimes not. Can anyone help me with this issue and i found that there is short between signal line and ground of the RPSMA connector.
What interface board are you using to connect the XBee to PC?
Xbee Grove Dev. Bd
Is the device configured as an End device?
What is the full part number of the module in question?
I’m having the same problem. I’m using a Xbee USB Adapter V2.1 from www.DFRobot.com
https://www.dfrobot.com/product-588.html
Thank you!
Gerardo and Funanbolo,
If this is the S2C module with the Zigbee firmware version installed, you enable the end device function by enable the sleep function (SM).
Eric
Digi Support