Hi There,
Is there a way of flashing the RCM3700 module using its main set of pins as opposed the the tiny ones on the top?
I would like to incorporate the programming cable circuit onto a prototype board I’m making.
many thanks
The RCM3700 has a reduced set of pins between the core module and the host board in comparison to most other Rabbit 3000 cores. This meant that many signals were left off to fit on the 40 available pins. The ports needed to program the unit are part of that. You have no access to SMODE0, SMODE1, or STATUS so even if you could re-route the port, these signals are not available.