I have a Xbee2 in Coordinator AT which is connected to a computer, a Xbee2 in Router AT which is connected to a breadboard and powered by Arduino’s +3.3V and GND rails.
Coordinator AT
atid
2001
atsl
40A74613
atdl
40B19213
Router AT
atid
2001
atsl
40B19213
atdl
40A74613
When I use Coolterm to send the command ATND from the Coordinator XBee, theres no response from the Router XBee. Connecting pin 13 of the Router Xbee to an LED causes the LED to light up, so I guess the Router Xbee is powered properly.
ATND on the Coordinator AT
atnd
0000
0013A200
40A74613
FFFE
00
00
C105
101E
00030000
However when I also connect the Router Xbee to the computer (so both Xbees are connected to the computer), ATND does get a response from the Router XBee.
ATND on the Router XBee
atnd
0000
0013A200
40A74613
FFFE
00
00
C105
101E
00030000
3626
0013A200
40B19213
FFFE
01
00
C105
101E
00030000
How can I troubleshoot this problem?