Connecting XBP24 to Exegin Q58 802.15.4 (Zigbee Pro) Coordinator

XBee & XBee Gateway XBee - Zigbee
,
1

Hello,
I do have a coordinator using the module Exegin Q58 802.15.4. The Coordinator is using the Stack Profile Zigbee PRO, Protocol Version 2.

I do have a XBP24-ASI-001 in a Sensor, which I would like to work as End Point. I’m trying to set it up and connect to the Coordinator Pan id with no success. I do appreciate your coaching on the following questions:

  1. Is it possible to configure the XBP24-ASI-001 to connect to a Zigbee Pro Network?

  2. if Yes, appreciate any guidance on the most important factors to configure other than Channel, Pan ID, Mac Mode (2 or 3?).
    thanks a lot
    Keiner

2

Your XBP24 module you are working with is NOT a zigbee enabled device but an IEEE 802.15.4 device.

3

Thanks. Would you please recommend me what is the model that support zigbee/zigbee PRO?

4

That would be any of the ones located at https://www.digi.com/products/xbee-rf-solutions/embedded-rf-modules-modems/xbee-zigbee