Hello,
How to setup an out of band telnet connection to a Router with Digi Passport?
I can dial in with my out of band connection. I can see the menu to do different things.
What should I do to connect to a device from this CLI ? There is nothing on this CLI menu on how to connect to a device.
- Network
- Serial port
- Clustering
- Power controller
- Peripherals
- System status & log
- System administration
- Activate Passport Locator LED
Thanks,
Chendra
From the command line, issue the portaccessmenu or connect command. Example:
portaccessmenu
connect 4 <– to connect to port 4
Thanks for the reply.
I don’t see any option on how to a command prompt (through Console connection or through a port connection). This is what I get when I dial in.
Thanks again,
Chendra
Welcome to Digi Passport 32 configuration page
Current time : 08/28/2014 10:44:27 Serial No. : SW80968897
F/W Rev. : v1.1.4 Bios Ver. : v1.0.1
MAC addr.(eth0): 00-40-9D-37-09-71 IP addr.(eth0) : 165.88.73.9
- Network
- Serial port
- Clustering
- Power controller
- Peripherals
- System status & log
- System administration
- Activate Passport Locator LED
[h]elp, [s]ave, [a]pply, e[x]it, [r]eboot